The main objective of this study is to provide basis data for the optimal design of an absorption refrigerating system of PlatenMunters type.
The absorption refrigerating system under consideration is a domestic small unit, and the corresponding specifications are
(1) refrigerant and absorbent are Ammonia and water respectively
(2) evaporator, rectifier, condenser and absorber consist of finned tubes
(3) both gas heat-exchanger and liquid heat-exchanger consist of double tubes.
The significant parameters of the system are taken to be the subcooling temperature of condenser the outlet temperature of liquid heat-exchanger and gas heat-exchanger, the concentration of diluted solution and concentrated solution of Ammonia, and generator pressure; which are evaluated at constant air temperature and constant air velocity.
The computational method of the optimal design of this type of refrigerating system is proposed.
An experiment has been conducted to measure the efficiency and performance of an absorption refrigerating system.
It is shown the optimal design conditions are significantly affected by the generator pressure, the concentration of diluted and concentrated solution, and the outlet temperature of liquid heat-exchanger, while the outlet temperature of gas heat-exchanger has little contribution to the performance.
The optimum design conditions of the refrigerating system are presented in the tabular and graphical forms.
Platen-Munters type 흡수식 냉동기에서 냉매 ( refrigerant)로서 암모니아를, 흡수제 ( Absorbent ) 로서 물을 사용하여 작동하는 것으로 공기의 속도는 14.572 ft/sec, 공기의 온도는 60℃로 정하고 압력은 3가지로 변화시키고 농도는 회용액과 농도액의 농도차를 0.05로 하여 작동이 불가능한 0.25 이하와 0.5이상을 제외한 전 농도에서 OPTIMAL 한 Point를 찾고 실험을 통하여 효율을 측정하였다. 여기에 따르면 전농도에서 150 psia 보다 200 psia가 OPTIMAL 압력이 되며 농도는 희용액이 0.3, 농용액이 0.4가 OPTIMAL 농도가 되며 액체열교환기 출구 온도의 변화가 Total cost에 가장 큰 영향을 미치고 있다.
여기서는 공냉식 Finned Tube를 사용한 것으로 하였으나 2중관 식으로 수냉식으로 하는 경우에도, 또 Model의 구조자체가 약간 변경되어도 위의 Computer Programming에 열전달식과 설계변수를 약간 변경시키고 Weighting factor만 적당히 정해지면 OPTIMAL Point를 찾을 수가 있다. 최적설계를 위한 구조는 그림3의 구조로 하였으나 bubble pump에 대한 정확한 실험이 필요하므로 제작이 불편하며 본 최적설계를 그림4의 구조에 적용시켜도 Generator의 구조의 변화는 본 설계에서 아무런 영향을 미치지 않으므로 이 최적 설계치를 그대로 사용할 수 있으며 bubble pump에 대한 실험이 없어도 되므로 제작이 용이하다.